MapEd Error "Not enough gates"

[MacinosaK]

Ive created a map in the RWM6.6 editor and when I run it it says an error: "Not enough gates". Ive placed the gates properly and they are very wide also, but the error is still there. Can anyone tell me what to do with it ???? I would be grateful !

[kuebel]

Oh and the locations are the areas where the units rally after they have spawned and reached the blue flag.

[MacinosaK]

Oh, thanks for the reply but I forgot to say that I got this error in multiplayer map, is it the same procedure there ? Because I still got those errors

[kuebel]

Yea, the screenshot is taken from a multiplayer map.
Have you tried what I said though?

[MacinosaK]

Oh yes indeed, it WORKS ! Thanks a LOOOT man

[kuebel]

You're welcome.

[MacinosaK]

Hello again, but OMG, Im such a lmao, now I start the game as 1v1 and it ends almost immediattely as a defeat for both sides. Maybe its because there are no units on both sides, but Ive set the initial reinforcements to come right after the game start. However it still ends as a defeat. The time out defeat delay is 5 mins. So now Im doomed without help

[kuebel]

If you would upload your map (or mission) as an attachment here, I could have a look.

Sounds like a scripting error.

[MacinosaK]

OK, here it is, hope it will help...

[kuebel]

The problem was, that you didn't give all nations reenforcements; which you have to do.
Just give the other Allied nations the RUS Reenf and the Japanese the GER Reenf if you have only two nations.

I've done it for you now and tested it, it works (see the attachment and put the folder into your map folder and load the mission 001 then).
What I noticed was: The way the zeppelines are set up now, the guy that starts on the left wins, since he gets all the heavy tanks.

[MacinosaK]

Oh yes, that was it, thx a lot again

[kuebel]

I saw that you had your map open, hope you had fun